General Laboratory Equipment

Approx. Rs 40,000 / NumberGet Latest Price

Approx. Rs 7,500 / NumberGet Latest Price

Additional Information:

Approx. Rs 22,000 / UnitGet Latest Price

Special Features of auto-tuning Digital Temperature Controller cum Indicator:

• Forced air circulation by F.H.P. continuous duty Motor for uniform heat distribution.
• Dual display microprocessor based PID Digital Temp. Indicator cum controller with sensor in place of thermostat and thermometer.
• Dual display microprocessor based Auto tuning PID Digital Temp. Indicator cum controller with soak timer and sensor in place of thermostat and thermometer. (See features mentioned below)
• Programmable microprocessor based dual display digital temperature controller.
• Dual display Digital timer with alarm.

Other Details:

• Heaters:80 / 20 Nichrome heating elements placed at bottom and sides for uniform heat distribution. (Based on MEMMERT GERMAN DESIGN)
• Standard supply:Perforated and adjustable aluminium trays, pilot indicating lamps, ON/OFF switches cord wire and power plug.

Specification:

Additional Information:

Approx. Rs 8,000 / NumberGet Latest Price

• With ind. ON/OFF switch
• With ind. Energy regulator
• With one energy regulator and ON/OFF Switch.

Additional Information:

Approx. Rs 65,000 / NumberGet Latest Price

Body made of cold rolled sheet duly powder coated. Table made of S. S. 304, front door of clear acrylic, UV lamps will be Phillips/equal imported make. Other standard accessories such as Manometer, gas inlet, castor wheels, illumination, additional power point are included in the price.

HEPA Filers:

Particleretention will be 0.3 micron at rated velocity, Pressure drop will be 23 mm WG, Efficiency 99.97%. Protected with specially perforated SS grill at the downstream side.

Pre-Filters:

Size will depend on the size selected. Particle retention down to 15 micron at rated velocity, Pressure drop 6 mm WG, Efficiency 90 % Protected with specially perforated SS grill.

Blower Assembly:

Consists of a 1/4 HP,1440 RPM, single phase Motor with double end shaft and a pair of aluminum centrifugal type impeller directly coupled on both ends of the motor & encased within an MS blower housing.

Material of Construction:

The complete LAMINAR AIR FLOW BENCH will be fabricated by using Powder coated CRC sheet with square pipes. Front door made of 6 mm clear acrylic(polycarbonate at extra cost) with double folding facility. Working table will be of complete stainless steel. Ultra violet lamp of 3 feet 30 watts-Philips- Holland make will be provided.

Standard Accessories:

The equipment will be provided with 40 watt daylight lamps with diffusers, Gas cock, castor wheels, pressure differential manometer, additional 5 amps power point, side screens made of 6 mm clear acrylic.

Note:

The Laminar Flow Cabinet can be made of S. S. Instead of mild steel at an extra cost . Price on request.

Pressure Differential Manometer will indicate the pressure behind the HEPA FILTER and after few years, the pressure will be more because of accumulation of dusts at the upstream side. Once the pressure level indicates above 22 mm WG in the manometer or the velocity at the downstream side falls below 60 feet per minute, the filters may be replaced. The velocity can be monitored by using external anemometer.

Working Size (Feet):
2 x 2 x 23 x 2 x 24 x 2 x 26 x 2 x 2

Approx. Rs 8,500 / NumberGet Latest Price

• 1800 1 140x155x100 9 x 25
• 1800 2 160x165x120 9 x 35
• 1800 5 190x190x170 13 x 50
• 1200 10 250x250x170 13 x 50

Approx. Rs 35,000 / NumberGet Latest Price

Approx. Rs 850 / NumberGet Latest Price

Approx. Rs 40,000 / SetGet Latest Price

Being an eminent organization in the industry, we are involved in providing a premium quality range of BOD Incubator.

Technical Specifications:

• Double walled cabinet mounted on castor wheels
• Full Length inner acrylic door permit inspection of specimens without disturbing the Temp
• Temp. Controlled by solid State Digital controllers housing all the control with PT-100 sensor illumination light are provided for viewing with door limit switch
• CFC Free hermetically sealed compressor provide temp.
• Air circulation fan for maintain Temp. Uniformity throughout the chamber
• Flush fitting insulated double walled door
• The Chamber is provided with modular removable shelves made of SS
• For complete flexibility in use to work on 230 volts 50 Hz

Safety Features:

• Built in Temp Deviation Audio visual alarm
• Safety thermostat for overshoot Temp. Cut off system
• HRC Fuses for compressor heater & mains
• Time daily circuit for safety of compressor.

Special Care: A suitable K V. A. Servo stabilizer is strongly recommended. 

This BOD Incubator is available in below sizes:

Approx. Rs 1.1 Lakh / PieceGet Latest Price

Approx. Rs 70,000 / PieceGet Latest Price

• DM2001 : Vertical
• DM-2002 : Horizontal

Body made of cold rolled sheet duly powder coated. Table made of S. S. 304, front door of clear acrylic, UV lamps will be Phillips/equal imported make. Other standard accessories such as Manometer, gas inlet, castor wheels, illumination, additional power point are included in the price.

The Laminar Flow Cabinet can be made of S. S. Instead of mild steel at an extra cost . Price on request.

Pressure Differential Manometer will indicate the pressure behind the HEPA FILTER and after few years, the pressure will be more because of accumulation of dusts at the upstream side. Once the pressure level indicates above 22 mm WG in the manometer or the velocity at the downstream side falls below 60 feet per minute, the filters may be replaced. The velocity can be monitored by using external anemometer.

Particleretention will be 0.3 micron at rated velocity, Pressure drop will be 23 mm WG, Efficiency 99.97%. Protected with specially perforated SS grill at the downstream side.

size will depend on the size selected. Particle retention down to 15 micron at rated velocity, Pressure drop 6 mm WG, Efficiency 90 % Protected with specially perforated SS grill.

consists of a 1/4 HP,1440 RPM, single phase Motor with double end shaft and a pair of aluminum centrifugal type impeller directly coupled on both ends of the motor & encased within an MS blower housing.

The complete LAMINAR AIR FLOW BENCH will be fabricated by using Powder coated CRC sheet with square pipes. Front door made of 6 mm clear acrylic(polycarbonate at extra cost) with double folding facility. Working table will be of complete stainless steel. Ultra violet lamp of 3 feet 30 watts-Philips- Holland make will be provided.

The equipment will be provided with 40 watt daylight lamps with diffusers, Gas cock, castor wheels, pressure differential manometer, additional 5 amps power point, side screens made of 6 mm clear acrylic.

The Laminar Flow Cabinet can be made of S. S. Instead of mild steel at an extra cost . Price on request.

Pressure Differential Manometer will indicate the pressure behind the HEPA FILTER and after few years, the pressure will be more because of accumulation of dusts at the upstream side. Once the pressure level indicates above 22 mm WG in the manometer or the velocity at the downstream side falls below 60 feet per minute, the filters may be replaced. The velocity can be monitored by using external anemometer.

Additional Information:

Approx. Rs 75,000 / NumberGet Latest Price

Approx. Rs 15,000 / NumberGet Latest Price

Approx. Rs 6,500 / UnitGet Latest Price

• Body made of mild steel with attractive paint. Sloping at front cover with large magnifying lens. Built in large free illumination with black reflection free background. Complete with woulfheugel, counting plate. Special pen type probe allows marking & counting simultaneously. Counting is registered on a four digit resettable Electronic counter. With audio beep at every count. A fluorescent light provides uniform day light illumination.

• Ordinary
• Digital

Approx. Rs 3,000 / NumberGet Latest Price

Approx. Rs 95,500 / UnitGet Latest Price

Approx. Rs 10,000 / NumberGet Latest Price

Approx. Rs 75,000 / NumberGet Latest Price